Home » Flash File » Xiaomi » Mi 11 Lite 5G Flash File (Renoir) Latest Firmware ROM

Mi 11 Lite 5G Flash File (Renoir) Latest Firmware ROM

Download Mi 11 Lite 5G Flash File, Firmware, Stock ROM. Official Latest Version MIUI12 Firmware File and The model codename of this Mi 11 Ultra is Renoir, which describes how to flash and driver Install from Xiaomi FlashTool. Here is how to flash Redmi Phone with a flash file, which is given below in full detail. How to Flash Manual.

Mi 11 Lite 5G Fastboot ROM:

Recovery ROM:

Update More: Download All Xiaomi Redmi Mobile Flash File (Stock ROM)

Mi 11 Lite 5G flash tool
Mi 11 Lite 5G Flash tool

If your phone is hanging, or the logo is hanging, then flashing with this firmware will solve all the problems of your phone. Remember to log in to the Mi account on your phone before flashing. Otherwise, an error can occur during flushing. Flashing a few models of Xiaomi removes the Mi account. Or you can unlock by flashing from MI Account unlock file

By flashing this Stock ROM, you can fix dead boot repair, phone unlock, hard reset, Xiaomi update.

How To Flash Mi 11 Lite 5G

  1. Download Mi 11 Lite 5G Flash File And Install Install Driver.
  2. Install the given Xiaomi flash tool, the USB driver of the phone is included in the flash tool
  3. Then extract the flash file from the zip file.
  4. Extract from the zip file after 7zip setup again.
  5. If the 7zip setup is not installed on your computer then install it. (7zip Link)
  6. After that Run the Xiaomiflash.exe From Desktop and select flash in it
  7. After that click on the option of the above selection in the tool and select the “image” folder in the folder where your flash files are.
  8. If you are flashing in Fastboot mode, select the “firmware” folder.
  9. After selecting the firmware, connect the phone to the computer.
  10. To get the phone into the EDL model, find and jumper the EDL point, and connect the data cable with the phone.
  11. After that select “Clean All” in the option given below and click the Refresh button which will show the com port in the tool.
  12. After that click on the flash button, the flash will start.

Note: During flashing, do not remove the data cable from the phone, otherwise the phone can go into a dead mode.

Leave a Reply

Your email address will not be published. Required fields are marked *