Swipe Halo Edge Tab Flash File (Firmware ROM)

Download Swipe Halo Edge Tab Flash File, Stock ROM, Official Firmware ROM. The given firmware file of Swipe the original file and it is in the IMG file, which describes how to flash and driver Install from SP FlashTool. Here is how to Flash Swipe Phone with a Scatter file, which is given below in full detail. How to Flash Manual.

If your phone is in dead mode, logo hangs, or the phone is locked, after flashing from this file all the problems will be fixed simultaneously and if you are locked with FRP then flashing will unlock it.

Before flashing, Swipe Halo Edge Tab Flash File from the link above and Must install the USB driver. And keep the phone battery charged 30%.

How to Flash Swipe Halo Edge Tab

  1. First of all download the above files.
  2. Extract All File From zipping Or Rar File.
  3. Open the Itel flash tool folder and run RKBatchTool.exe File
  4. After that click on the load packet button and select an IMG file from the given flash file folder.
  5. Wait for some time till the file is loaded
  6. Then click on the download button
  7. To connect the phone to the tool, put the phone in download mode.
  8. Switch off the phone and press the volume up and down simultaneously and Plugin Data Cable.
  9. Flashing will start waiting until flashing occurs.
  10. During flashing the data cable may not go out of the phone or the phone can go into dead mode.

Note: During flashing, do not remove the data cable from the phone, otherwise the phone can go into a dead mode.

Leave a Comment

error: Content is protected !!